Braking resistors are often stopped in speed controllers to stop or slow down electric motors. Especially in motors with high inertia, braking resistors are important for the motor to work as a generator and not feed the network. Thus, the reliability of the system is always under control. Dynamic braking resistors are used in order to ensure fast stopping or decrease the speed of AC and DC electric motors controlled by speed drives (speed control devices). Due to kinetic energy, an electric motor continues to rotate for a short time even after it has been switched off. As the rotor keeps rotating, the motor starts acting as a generator and feeding the drive. This may not only increase the stopping time of the motor, but also cause a voltage increase on DC drive’s terminal leading to an over voltage fault and consequently a shut down.In order to avoid such problems, a breaking resistor of a proper resistance value and rated power should be connected to the DC drive’s terminal.

 

 

Braking resistors are frequently used in electric motors.

 

Applications Using Braking Resistors

Braking Resistors are used in many motor applications that is controlled with driver.

  • Vertical and horizontal movements of fixed cranes, portal bridge cranes, overhead mobile cranes and tower cranes
  • Mobile facade platforms used for construction and maintenance of buildings, facade hoists and elevators, cradle systems
  • Lifts and elevators controlled by a driver and operated by a synchronous (geared) and asynchronous (gearless) motors
  • DC and AC servo motordrives used in robot control, digital control and position controller automation systems
  • Vertical or angular movement systems such as conveyors or loaders
  • Mixing, crushing and drum applications at mines
  • Reel applications at cable, wire or textile manufacturing plants
  • Factory doors controlled by motor drives
  • Machinery and presses where heavy loads are moved instantly
  • Railway vehicles and hybrid or electrical road vehicles
  • Wind turbines

 

Braking resistors have a wide range of applications in the industry. Wind farms are just one of them. 

Determination of Power and Resistance values of Braking Resistor

Resistance value of the braking resistor changes based on the drive. This can be detected by the driver’s manufacturer. This value is specified in the drive’s user guide. If this value is given as Rmin and Rmax, the resistance should be close to Rmin and but not lower than Rmin. Braking time extends as it gets closer to Rmax. The resistance power is determined based on the application used by the motor to which the drive is connected. It can be determined with special engineering calculations or specified by the company based on our experience on frequently used applications. In some cases, the power of resistance can be equal to the motor power, or even up to ten times smaller than it.

Abdullah Hussain

Recent Posts

Which Household Problems You Need To Fix Before Moving In

Finding a new home is not easy. It takes countless hours of research and even…

14 hours ago

Choose From These Ascendancies For Archmage Build To Start Your POE 3.24 Necropolis League!

Archmage is receiving some huge buffs in terms of sustainability and league start viability. So…

2 days ago

Future Expectations for the Rental Market

It's critical to investigate projections for the rental market as the real estate sector changes…

2 days ago

Why White Ceiling Fans With Lights Are the Best Choice for Your Home

You walk into your living room and look up. Staring back at you is that…

3 days ago

Thesparkshop.in:product – Earbuds for Gaming Low Latency Gaming Wireless Bluetooth Earbuds

Thesparkshop.in:product/earbuds-for-gaming-low-latency-gaming-wireless-bluetooth-earbuds: In the game industry every second is important. When you're in the middle of a…

4 days ago

About Thesparkshop.in:product/batman-style-wireless-bt-earbuds

Thesparkshop.in:product/batman-style-wireless-bt-earbuds: The era where gadgets seamlessly blend with fashion, the convergence of style and technology…

5 days ago