How to Assemble and Install a Downspout Extension

Downspouts are a great way to prevent water from overflowing onto the ground in your yard. They are typically installed near the edge of the wall so water can flow away without causing damage. In fact, Gutterilla offering downspout extension has kits to help you find some solutions if you need a little more length. However, over time downspouts may become damaged and need to be replaced. Fortunately, the process of replacing a downspout extension isn’t too difficult and can be accomplished in only a few simple steps. This post will discuss the process of replacing a downspout extension in your yard. But first, let’s look at why you might need a  downspout extension.

What is a Downspout Extension?

A downspout extension is an attachment that is attached to an existing downspout to make it longer. The length of the extension will depend on your particular needs. There are several different kinds of extensions that can be used to add length to a downspout, including a metal drop unit and a pre-made vinyl ester (plastic) product. It’s important that the extension you buy fits your existing downspout, so it is compatible with the rest of your rain gutter system.

Why Do I Need a Downspout Extension?

Most downspouts are installed at the edge of the house or at a corner, as these locations are typically high and prone to water splash. However, even if your downspout is installed properly, it may not extend far enough to reach all areas of the property. So if you want to ensure that water is directed away from the house uniformly, you will need to extend it with a downspout extension kit.

Here Are Steps To Install And Assemble A Downspout Extension.

Step 1:Measuring the Outlet

The first step is to determine the exact length of downspout you need to replace. This can be done by measuring from the edge of the ground to where it meets your house. You can use a wooden board and measuring tape to make this easier. Most of them go for two by three or three by four inches, so marking your measurements on a piece of paper will give you an idea of what is needed. In fact, most of these products are always assembled so that it is easier to 

 assemble and install your new downspout extension.

Step 2. Connecting the Downspout Extension to the Elbow 

The next step is connecting the downspout to the elbow. To do this, you will need to purchase a fitting that is appropriate for what you are using. The elbow should be the same height as your house, so you can use plumbing tape if needed. Make sure that the water flows freely out of the elbow and into the downspout. It might be necessary to cut the elbow a little bit shorter to fit perfectly with the downspout.

Step 3. Sealing the Downspout Extension

After you have connected the downspout and elbow, you can start to seal them. This will help to create an airtight seal and prevent any leaks. You can use Zipp screws or Snap-On attachments to keep the connection area watertight. However, remember that Zipp screws should be only half an inch. And the screw should not be too long. This is because long screws can catch small twigs and leaves, causing the downspout to clog and preventing water from flowing out of it.

Step 4. Cutting the Downspout to the Right Size

The last step is to cut the downspout to the right size. You can use a band saw, and a few simple miter cuts to make this easy. You need to make sure that you do not cut the downspout too short. The walls of your home and your house foundation are considered as part of the waterway, so cutting them short may end up causing a flood if water gets into it. So be sure to raise the downspout to a level that is above the foundation and high enough so that it will not interfere with your landscaping.

As you can see, replacing a downspout extension is easy to do and doesn’t take that much time to complete. If your downspout needs replacing, you can seek professional help from a guards Installation company, this way, and you can be sure that your downspout will prevent flooding. In addition to helping you avoid a flood, it will also improve your home’s drainage system and provide additional storage space for rainwater.