How To Connect Your Fountains With An Electronic Water Level Sensor

Water fountains are a great way to create additional water features in your garden. However, it can be difficult to know when it’s time to refill the fountain if you don’t have an electronic water level sensor attached. This article explains how to install an electronic water level sensor with a few helpful tips along the way!

What is an electronic water level sensor?

An electronic level sensor is a device that is used to measure the depth of water in an aquifer or well. It usually consists of a transmitter and receiver, with a float that moves up and down due to changes in water level. The transmitter sends an electronic signal to the receiver, which displays the current water level.

How do I install an electronic water level sensor?

Installing an electronic water level sensor on your fountain is a simple process that can help ensure accurate water levels and prevent issues such as clogged filters or overflowing tanks. Follow these steps to connect the sensor and get started: 

Remove the old water level sensor. On most fountains, the sensor is mounted on a bracket near the top of the fountain. Use a Phillips screwdriver to remove the screws that hold it in place. Once the bracket is removed, you can lift off the sensor. 

Connect the new sensor to the fountain using the included wire connectors. Make sure that the black (LO) and white (HI) wires are connected to corresponding wires on the sensor, and tighten the screws that hold it in place. 

Replace the bracket and screws, and reattach the sensor to your fountain. Be sure to replace any plastic or metal pieces that were removed during installation, such as the water level indicator light cover.

How to connect the sensors?

If you want to connect your fountains with an electronic water level sensor, there are a few different ways to go about it. You can use a wired or wireless connection, depending on what type of sensor you have and how much wiring you want to do. Wired connections are usually simpler and faster, but wireless connections are more reliable and can be used in locations that are difficult or impossible to access a wired connection.

Final thoughts:

If you want to automate your fountain’s watering, you’ll need an electronic water level sensor. This type of sensor attaches to the fountain’s spout and monitors how high or low the water level is. Once the sensor detects that the water level has fallen below a certain point, it will automatically start watering the fountain again.

Once you’ve chosen your sensor, connect it to your water line using an adapter or cable. You can then set up your water level monitoring system by installing a smart home device like a Nest thermostat or Wink Hub. Once your system is set up, you’ll be able to check the water level in your fountain anytime using your smartphone app or computer monitor.