Improper usage and old age can cause showers, sinks, and baths to suffer damage and cause leakage. According to Matthew Davies Stockton, it is crucial to fix any leakage with a sealant to prevent mold and other issues. In most cases, simply sealing the required areas on sinks, showers, or baths with a silicone sealant would help resolve most issues. Here are the steps you can follow to reseal your showers and sinks:
1. Clean the area to be sealed – The first step is to clean the counter, tub, sink, or other such areas before you may apply the sealant. You can use a utility knife, plastic caulk remover, small screwdriver, and other such tools to clear the old silicone and use alcohol to clean the surface properly. There should be no grease or oil left. Otherwise, the silicone would not be able to bond with the surface properly.
This step is a little tiresome but necessary to ensure a watertight bond between the sealant and the crevices that need to be sealed.
2. Choose the appropriate sealant or tool – There are several types of product available in the market that you may use to seal the required area. If you want to use a silicone gum, you have to test the sealing after loading a tube of silicone into the gun. Alternatively, you may use a sealant product that comes in a tube for easy application.
3. Apply the seal on the required area – Hold the silicone gun at a 45-degree angle and apply enough pressure on the handle to squeeze the necessary amount of silicone sealant. Make sure you don’t overdo it as it is not easy to remove the extra. The goal is to apply the sealant at a continual, even flow. Silicone guns may feel a bit tricky to use if you are using it for the first time. So, make sure to apply the silicone at a steady rate. Finally, pull away and release the silicon gun handle once you are done to eliminate any silicone string.
If you use a product like Kwik Seal that comes with a tube filled with the sealant, you just have to apply thorough and steady pressure on the tube while applying it on the sinks or showers. Again, you have to ensure that you don’t apply too much as these products come in limited quantities.
4. Check for gaps – Sometimes, you may notice a few gaps due to air bubbles between the surface and the sealant. To remove those, you can wear a glove and use your index finger to spread the sealant properly. Now, you just have to wait for the silicone to dry and smooth the edges to create a flawless finish.
Silicone sealants can take a few days or even up to a week to dry completely. Matthew Davies Stockton believes that you should try your best to not disturb the area during this time to ensure a smooth seal.